Honda CR-V: Doors
Honda CR-V (2006–2011) Service Manual / Body / Doors
Component Location Index-Front Door
- DOOR CENTER OUTER TRIM
- DOOR LINING BRACKETS
- DOOR OUTER MOLDING
- Replacement
- DOOR GLASS OUTER
WEATHERSTRIP
- Replacement
- HINGE
- DOOR CHECKER
- DOOR
- Position Adjustment
- SPEAKER
- DOOR WEATHERSTRIP
- Replacement
- PLASTIC COVER
- DOOR GLASS INNER WEATHERSTRIP
- DOOR PANEL
- POWER WINDOW SWITCH
- GLASS RUN CHANNEL
- GLASS
- FRONT LOWER CHANNEL
- CENTER LOWER CHANNEL
- REGULATOR
- RETAINER
- SPACER
- DOOR CYLINDER
- INNER HANDLE
- INNER HANDLE CAP
- LATCH CABLE
- LATCH
Component Location Index-Rear Door
- DOOR OUTER MOLDING
- DOOR GLASS OUTER WEATHERSTRIP
- DOOR QUARTER OUTER TRIM
- DOOR CENTER OUTER TRIM
- DOOR CHECKER
- HINGE
- DOOR
- DOOR PANEL
- POWER WINDOW SWITCH
- BRACKET
- DOOR WEATHERSTRIP
- PLASTIC COVER
- CENTER LOWER CHANNEL
- GLASS
- REGULATOR
- OUTER HANDLE
- LATCH PROTECTOR
- OUTER HANDLE PROTECTOR
- LATCH
- LATCH CABLE
- STRIKER
- INNER HANDLE CABLE
- INNER HANDLE CAP
- INNER HANDLE
READ NEXT:
Front Door
Front Door Panel Removal/Installation
Special Tools Required
KTC trim tool set SOJATP2014 *
Trim pad remover, Snap-on A 177 A or equivalent,
commercially available
* Available through the Ameri
Rear Door
Rear Door Panel Removal/Installation
Special Tools Required
KTC trim tool set SOJATP2014 *
Trim pad remover, Snap-on A 177 A or equivalent,
commercially available
* Available through the Americ
Mirrors
Component Location Index
POWER MIRROR ACTUATOR
Replacement
POWER MIRROR
Replacement
MIRROR HOLDER
Replacement
MOUNT
REARVIEW MIRROR
Replacement
Power Mirror Replac
SEE MORE:
Dual Pump System Function Test
Starting and accelerating in forward gears
(4WD mode)
NOTE: Do not test repeatedly or the fluid will overheat.
1. Lift up the vehicle so all four wheels are off the ground.
2. Make a mark (A) on either No.1 or No.2 propeller
shaft (B).
3. Start the engine, and let it run until it warms up (the
ra
Emissions Testing
Testing of Readiness Codes
If you take your vehicle for an
emissions test shortly after the
battery has been disconnected or
gone dead, it may not pass the test.
This is because of certain ‘‘readiness
codes’’ that must be set in the onboard
diagnostics for the emissions
systems
© 2016-2025 Copyright www.hcrv.net
