Honda CR-V: Seats
Honda CR-V (2006–2011) Service Manual / Body / Seats
Component Location Index
- REAR SEAT
- Removal/Installation
- Armrest Removal/Installation
- Armrest Cover Replacement
- Right Rear Seat Cover Replacement
- Left Rear Seat Cover Replacement
- Right Seat-back Lock Control Cable Replacement
- FRONT SEAT
- Front Seat Active Head Restraint Inspection
- Removal/Installation
- Seat Frame Replacement
- Recline Cover Removal/Installation
- Seat-back Cover/Pad Replacement
- Seat Cushion Cover/Pad Replacement
- Center Table Replacement
- Armrest Removal/Installation
- Under Tray Replacement
READ NEXT:
Front Seat
Front Seat Active Head Restraint Inspection
NOTE: If the vehicle has been in a collision, always
inspect the active head restraints, even if they appear
reusable, by doing the following procedure.
Res
Rear Seat
Rear Seat Armrest Removal/Installation
NOTE: Take care not to tear the seams or damage the
seat covers.
1. Remove the E-ring (A) from the right side portion
on the armrest pivot.
2. Slide the armres
SEE MORE:
Valve Clearance Adjustment
Special Tools Required
Adjuster 07MAA-PR70110
Locknut wrench 07MAA-PR70120
NOTE: Adjust the valves only when the cylinder head
temperature is less than 100 ºF (38 ºC).
1. Remove the cylinder head cover.
2. Set the No.1 piston at top dead center (TDC). The
punch mark (A) on the variable valve
Windshield Wiper
1. MIST
2. OFF
3. INT Intermittent
4. LO Low speed
5. HI High speed
6. Windshield washers
Push the right lever up or down to
select a position.
MIST - The wipers run at high
speed until you release the lever.
OFF - The wipers are not activated.
INT - The wipers operate every
few s
© 2016-2025 Copyright www.hcrv.net
