Honda CR-V: Interior Trim

Component Location Index

Honda CR-V. Interior Trim

READ NEXT:

 Trim Removal/Installation

Trim Removal/Installation-Door Areas Special Tools Required KTC trim tool set SOJATP2014 * * Available through the American Honda Tool and Equipment Program; call 888-424-6857 SRS components are loc

 Sunvisor Removal/Installation

Special Tools Required KTC trim tool set SOJATP2014 * * Available through the American Honda Tool and Equipment Program; call 888-424-6857 NOTE: Put on gloves to protect your hands. Use the appropr

 Headliner Removal/Installation

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service. NOTE: Put on gloves to protect your hands. Use the a

SEE MORE:

 Front Driveshaft Installation

1. Apply grease to the contact area (A) of the outboard joint and front wheel bearing. NOTE: Failure to apply grease may cause excessive noise and vibration. 2. Install a new set ring (A) onto the set ring groove (B) of the driveshaft (left driveshaft). 3. Apply 0.5-1.0 g (0.02-0.04 oz) of grease

 DTC Troubleshooting

DTC B1028: Rear Window Wiper Motor (As) Signal Error NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A. 1. Clear the DTCs with the HDS. 2. Turn the. ignition switch OFF, and then back ON (II). 3. Operate the rear window wiper f

© 2016-2025 Copyright www.hcrv.net