Honda CR-V: Doors
Honda CR-V (2006–2011) Service Manual / Body / Doors
Component Location Index-Front Door
- DOOR CENTER OUTER TRIM
- DOOR LINING BRACKETS
- DOOR OUTER MOLDING
- Replacement
- DOOR GLASS OUTER
WEATHERSTRIP
- Replacement
- HINGE
- DOOR CHECKER
- DOOR
- Position Adjustment
- SPEAKER
- DOOR WEATHERSTRIP
- Replacement
- PLASTIC COVER
- DOOR GLASS INNER WEATHERSTRIP
- DOOR PANEL
- POWER WINDOW SWITCH
- GLASS RUN CHANNEL
- GLASS
- FRONT LOWER CHANNEL
- CENTER LOWER CHANNEL
- REGULATOR
- RETAINER
- SPACER
- DOOR CYLINDER
- INNER HANDLE
- INNER HANDLE CAP
- LATCH CABLE
- LATCH
Component Location Index-Rear Door
- DOOR OUTER MOLDING
- DOOR GLASS OUTER WEATHERSTRIP
- DOOR QUARTER OUTER TRIM
- DOOR CENTER OUTER TRIM
- DOOR CHECKER
- HINGE
- DOOR
- DOOR PANEL
- POWER WINDOW SWITCH
- BRACKET
- DOOR WEATHERSTRIP
- PLASTIC COVER
- CENTER LOWER CHANNEL
- GLASS
- REGULATOR
- OUTER HANDLE
- LATCH PROTECTOR
- OUTER HANDLE PROTECTOR
- LATCH
- LATCH CABLE
- STRIKER
- INNER HANDLE CABLE
- INNER HANDLE CAP
- INNER HANDLE
READ NEXT:
Front Door
Front Door Panel Removal/Installation
Special Tools Required
KTC trim tool set SOJATP2014 *
Trim pad remover, Snap-on A 177 A or equivalent,
commercially available
* Available through the Ameri
Rear Door
Rear Door Panel Removal/Installation
Special Tools Required
KTC trim tool set SOJATP2014 *
Trim pad remover, Snap-on A 177 A or equivalent,
commercially available
* Available through the Americ
Mirrors
Component Location Index
POWER MIRROR ACTUATOR
Replacement
POWER MIRROR
Replacement
MIRROR HOLDER
Replacement
MOUNT
REARVIEW MIRROR
Replacement
Power Mirror Replac
SEE MORE:
Fasten and Position the Seat Belts
Insert the latch plate into the buckle,
then tug on the belt to make sure the
belt is securely latched. Check that
the belt is not twisted, because a
twisted belt can cause serious
injuries in a crash.
The seat belt in the center position
of the back seat can be unlatched
and retracte
Horns
Component Location Index
HORN
HORN SWITCH
HORN RELAY CIRCUIT
(Built into the MICU)
CABLE REEL
UNDER-DASH FUSE/RELAY BOX
Circuit Diagram
Horn Switch Test
1. Remove the steering column covers.
2. Disconnect the dashboard wire harness 20P
connector (A) from the cable reel (B).
3. Usin
© 2016-2025 Copyright www.hcrv.net
