Honda CR-V: Fuel and Emissions Systems
Honda CR-V (2006–2011) Service Manual / Fuel and Emissions / Fuel and Emissions Systems
Special Tools
-
Fuel Sender Wrench
-
Fuel Pressure Gauge Attachment Set
-
Vacuum/Pressure Gauge, 0-4 in.Hg
-
Pressure Gauge Adapter
-
Oil Pressure Hose
-
A/T Pressure Hose
-
A/T Low Pressure Gauge W/Pane
-
A/T Pressure Hose, 2,210 mm
-
A/T Pressure Hose, Adapter
-
Fuel Pressure Gauge
READ NEXT:
General Troubleshooting Information
Intermittent Failures
The term "intermittent failure" means a system may
have had a failure, but it checks OK now. If the
malfunction indicator lamp (MIL) on the dash does not
come on, check for poor
System Description
Electronic Control System
The functions of the fuel and emission control systems are managed by the
powertrain control module (PCM).
Self-diagnosis
The PCM detects a failure of a signal from a sensor
How to Set Readiness Codes
Malfunction Indicator Lamp (MIL) Indication
(In relation to Readiness Codes)
The vehicle has certain "readiness codes" that are part
of the on-board diagnostics for the emissions systems.
If the vehi
SEE MORE:
Carrying Cargo in the Cargo Area or on a Roof Rack
Distribute cargo evenly on the
floor of the cargo area, placing the
heaviest items on the bottom and
as far forward as possible. Tie
down items that could be thrown
about the vehicle during a crash or
sudden stop.
Do not stack items higher than the
back of the rear seats. They can
b
Rear Differential Fluid Inspection and
Replacement
1. With the vehicle on level ground, inspect the
differential fluid with the ignition switch turned to
LOCK (0).
2. Use solvent and a brush to wash off any oil and dirt
from the differential fluid inspection oil filler plug.
3. Remove the oil filler plug (A) and the sealing
washer (B), then check
© 2016-2025 Copyright www.hcrv.net
