Honda CR-V: Interior Trim

Component Location Index

Honda CR-V. Interior Trim

READ NEXT:

 Trim Removal/Installation

Trim Removal/Installation-Door Areas Special Tools Required KTC trim tool set SOJATP2014 * * Available through the American Honda Tool and Equipment Program; call 888-424-6857 SRS components are loc

 Sunvisor Removal/Installation

Special Tools Required KTC trim tool set SOJATP2014 * * Available through the American Honda Tool and Equipment Program; call 888-424-6857 NOTE: Put on gloves to protect your hands. Use the appropr

 Headliner Removal/Installation

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service. NOTE: Put on gloves to protect your hands. Use the a

SEE MORE:

 DTC P0122: TP Sensor A Circuit Low Voltage

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the ignition switch ON (II). 2. Clear the DTC with the HDS. 3. Check TP SENSOR A in the DATA LIST with the HDS. Is there about 0.3 V or less? YES-Go to ste

 Damper/Spring

Damper/Spring Removal and Installation Removal 1. Raise the rear of the vehicle, and support it with safety stands in the proper locations. 2. Remove the rear wheel. 3. Remove the lid (A) on the cargo area side trim panel by releasing the hooks (B). 4. Remove the flange nuts (C) from the top o

© 2016-2025 Copyright www.hcrv.net