Honda CR-V: Fuel Supply System
Honda CR-V (2006–2011) Service Manual / Fuel and Emissions / Fuel Supply System
Component Location Index
-
FUEL RAIL
-
FUEL FEED LINE
-
FUEL TANK
-
FUEL TANK UNIT
-
FUEL PUMP
-
FUEL GAUGE SENDING UNIT
-
FUEL PRESSURE REGULATOR
-
FUEL FILTER
-
FUEL FILL CAP
-
FUEL FILL PIPE
-
FUEL LINE/QUICK-CONNECT FITTING
-
FUEL VAPOR LINE
-
FUEL LINE/QUICK-CONNECT FITTING
-
POWERTRAIN CONTROL MODULE (PCM)
-
PGM-FI MAIN RELAY 1
-
PGM-FI MAIN RELAY 2 (FUEL PUMP)
READ NEXT:
DTC Troubleshooting
DTC P0461: Fuel Level Sensor (Fuel Gauge
Sending Unit) Range/Performance Problem
NOTE:
Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshoo
Fuel Pump Circuit Troubleshooting
If you suspect a problem with the fuel pump, check that
the fuel pump actually runs; when it is on, you will hear
some noise if you listen to the fuel fill port with the fuel
f ill cap removed. The fu
Fuel Pressure Relieving
Before disconnecting fuel lines or hoses, relieve
pressure from the system by disabling the fuel pump
and then disconnecting the fuel tube/quick connect
fitting in the engine compartment.
With the HDS
SEE MORE:
DTC P16CO: PCM A/T Control System
Incomplete Update
NOTE:
Before you troubleshoot, record all freeze data and any on-board
snapshot, and review General Troubleshooting Information.
This code is indicated when PCM updating is
incomplete.
1. Update the A/T software in the PCM.
2. Check whether the DTC P16CO is indicated in the
DTCs/Freeze Data
Cylinder Head Cover Removal/Installation
Cylinder Head Cover Removal
1. Remove the intake manifold cover.
2. Remove the four ignition coils.
3. Disconnect the evaporative emission (EVAP)
canister purge valve connector.
4. Remove the dipstick (A), the breather hose (B), and
power steering (P/S) hose clamp (C).
5. Remove two bolts (D) se
© 2016-2025 Copyright www.hcrv.net
