Honda CR-V: Engine Lubrication
Honda CR-V (2006–2011) Service Manual / Engine Mechanical / Engine Lubrication
Special Tools
-
Oil Filter Wrench
Component Location Index
-
OIL PAN
-
WASHER
-
DRAIN BOLT
-
OIL PUMP
-
OIL PUMP CHAIN GUIDE
-
OIL PUMP CHAIN TENSIONER
-
OIL CONTROL ORIFICE
-
OIL FILTER
-
OIL FILTER FEED PIPE
-
OIL FILTER BASE
-
ENGINE OIL GALLERY CAP
-
OIL PRESSURE SWITCH
Symptom Troubleshooting Index
Low Oil Pressure Indicator Circuit Diagram
READ NEXT:
Low Oil Pressure Indicator Circuit
Troubleshooting (Open)
1. Connect the Honda Diagnostic System (HDS) to the
data link connector (DLC) (see step 2).
2. Turn the ignition switch ON (II).
3. Make sure the HDS communicates with the vehicle
and the powertrain
Oil Pump Overhaul
Exploded View
Oil Pump Removal
1. Turn the crankshaft pulley so its top dead center
(TDC) mark (A) lines up with the pointer (B).
2. Remove the oil pan.
3. Remove and discard the oil pump chain ten
Intake Manifold and Exhaust System
Intake Manifold Removal and Installation
Exploded View
Removal
1. Remove the hood support rod, then use it as shown
to prop the hood in the wide-open position.
2. Remove the bulkhead cover.
3. Disc
SEE MORE:
Additional Safety Precautions
Do not attempt to deactivate your
airbags. Together, airbags and
seat belts provide the best
protection.
Do not tamper with airbag
components or wiring for any
reason. Tampering could cause
the airbags to deploy, possibly
causing very serious injury.
Do not expose the front passenger
Camshaft Inspection
NOTE: Do not rotate the camshaft during inspection.
1. Remove the rocker arm assembly.
2. Put the rocker shaft holders, camshaft, and
camshaft holders on the cylinder head, then tighten
the bolts, in sequence, to the specified torque.
NOTE: If the engine does not have bolt 21, skip it
and continu
© 2016-2026 Copyright www.hcrv.net
