Honda CR-V: Service Station Procedures

READ NEXT:

 Refueling

1. Park with the driver’s side closest to the service station pump. 2. Open the fuel fill door by pulling on the handle located under the lower left corner of the dashboard. 3. Remove th

 Check Fuel Cap Message

Your vehicle’s onboard diagnostic system will detect a loose or missing fuel fill cap as an evaporative system leak. The first time a leak is detected a ‘‘CHECK FUEL CAP’’ message

 Opening and Closing the Hood

1. Park the vehicle, and set the parking brake. Pull the hood release handle located under the lower left corner of the dashboard. The hood will pop up slightly. 2. Reach in between the ho

SEE MORE:

 DTC P2122: APP Sensor A (Throttle Position Sensor D) Circuit Low Voltage

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the ignition switch ON (Ill. 2. Check APP SENSOR A in the DATA LIST with the HDS. Is there about 0.2 V or less? YES-Go to step 3. NO-Intermittent failure, t

 Cylinder Head Removal

NOTE: Use fender covers to avoid damaging painted surfaces. To avoid damage, unplug the wiring connectors carefully while holding the connector portion. To avoid damaging the cylinder head, wait until the engine coolant temperature drops below 100 ºF (38 ºC) before loosening the cylinder h

© 2016-2025 Copyright www.hcrv.net