Honda CR-V: EVAP System
Component Location Index

- EVAPORATIVE EMISSION (EVAP)
CANISTER PURGE VALVE
- POWERTRAIN CONTROL MODULE (PCM)
- General Troubleshooting Information
- Replacement

- FUEL TANK VAPOR CONTROL VALVE
- FUEL FILL CAP
- FUEL TANK PRESSURE
(FTP) SENSOR
- EVAPORATIVE EMISSION
(EVAP) CANISTER
- EVAPORATIVE EMISSION (EVAP)
CANISTER VENT SHUT VALVE
READ NEXT:
Special Tools Required
Vacuum pump/gauge, 0-30 in.Hg, Snap-on YA4000A
or equivalent, commercially available.
NOTE: Before you troubleshoot, record all freeze data
and any on-board snapshot, and revie
NOTE:
Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
If DTC P2422 is stored at the same time as DTC P0451,
trouble
SEE MORE:
You can also select a folder or file by
using the VOL/SELECT knob. Push
the VOL/SELECT knob to switch
the display to the folder or file list,
then turn the VOL/SELECT knob to
select a folder or file. Press the
VOL/SELECT knob to set your
selection.
Pressing the
button goes back
to
Special Tools
Backprobe set
Component Location Index
SERVICE VALVE (HIGH-PRESSURE SIDE)
SERVICE VALVE (LOW-PRESSURE SIDE)
EVAPORATOR CORE (Located-in the heater unit)
RECEIVER/DRYER DESICCANT
Replacement
A/C CONDENSER
Replacement
Clutch Check
Clutch Overhaul
Thermal Prote
© 2016-2025 Copyright www.hcrv.net
