Honda CR-V manuals

Honda CR-V: Windshield Wiper

Honda CR-V (2006–2011) Owner's Manual / Instruments and Controls / Windshield Wipers and Washers / Windshield Wiper

1. MIST

1. MIST
2. OFF
3. INT Intermittent
4. LO Low speed
5. HI High speed
6. Windshield washers

Push the right lever up or down to select a position.

MIST - The wipers run at high speed until you release the lever.

OFF - The wipers are not activated.

INT - The wipers operate every few seconds. At low speed and high speed, the wipers run continuously.

On all models except LX

Vary the delay by turning the adjustment ring. If you turn it to the shortest delay (wipers change to low speed position), the wipers change to low speed operation when the vehicle speed exceeds 12 mph (20 km/h).

The length of the wiper interval is varied automatically according to the vehicle’s speed.

LO - The wipers run at low speed.

HI - The wipers run at high speed.

READ NEXT:

 WindshieldWashers

Pull the wiper control lever toward you, and hold it. The washers spray until you release the lever. The wipers run at low speed, then complete one more sweep after you release the lever.

 Rear Window Wiper and Washer

1. OFF When you turn the wiper switch to the ‘‘OFF’’ position, the wiper will return to its parked position. 2. Rotate the switch clockwise to turn the rear window wiper ON. The

 Turn Signal and Headlights

1. Turn Signal 2. OFF 3. Parking and interior lights 4. AUTO 5. Headlights on 6. High Beams 7. Flash high beams *: If equipped Turn Signal - Push down on the lever to signal a left turn

SEE MORE:

 Rear Door

Rear Door Panel Removal/Installation Special Tools Required KTC trim tool set SOJATP2014 * Trim pad remover, Snap-on A 177 A or equivalent, commercially available * Available through the American Honda Tool and Equipment Program; call 888-424-6857 NOTE: Use the appropriate tool from the KTC

 Knuckle/Hub/Wheel Bearing Replacement

Exploded View Special Tools Required Hub dis/assembly tool 07GAF-SD40100 Ball joint remover, 32 mm 07MAC-SL0A102 Ball joint remover, 28 mm 07MAC-SL0A202 Ball joint thread protector, 14 mm 071AF-S3VA000 Attachment, 72 x 75 mm 077 46-0010600 Driver 077 49-0010000 Attachment, 96 mm 07948-SB001

© 2016-2025 Copyright www.hcrv.net