Honda CR-V: Electronic Throttle Control System
Honda CR-V (2006–2011) Service Manual / Fuel and Emissions / Electronic Throttle Control System
Component Location Index
- ELECTRONIC THROTTLE
CONTROL SYSTEM (ETCS)
CONTROL RELAY (RELAY SOCKET F) - POWERTRAIN CONTROL
MODULE (PCM)
- General Troubleshooting Information
- Replacement
- THROTTLE ACTUATOR and THROTTLE POSITION (TP) SENSOR
-
ACCELERATOR PEDAL MODULE
-
Removal/Installation
-
-
ACCELERATOR PEDAL POSITION (APP) SENSOR
-
Signal Inspection
-
READ NEXT:
DTC P0122: TP Sensor A Circuit Low Voltage
NOTE: Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
1. Turn the ignition switch ON (II).
2. Clear the DTC with the HD
DTC P1658: ETCS Control Relay ON
Malfunction
NOTE: Before you troubleshoot. record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
1. Turn the ignition switch ON (II).
2. Do the ETCS TEST in the
SEE MORE:
ThreeWay Catalytic Converter
The three way catalytic converter
contains precious metals that serve
as catalysts, promoting chemical
reactions to convert the exhaust
gasses without affecting the metals.
The catalytic converter is referred to
as a three-way catalyst, since it acts
on HC, CO, and NOx. A replacement
Navigation Unit Removal/Installation
SRS components are located in this area. Review the SRS component location.
Also review the precautions and procedures in the SRS section before doing repairs or
service.
NOTE:
Put on gloves to protect your hands.
Take care not to scratch the dashboard and related
parts.
Lay a workshop towel u
© 2016-2025 Copyright www.hcrv.net
