Honda CR-V manuals

Honda CR-V: Daytime Running Lights

Honda CR-V (2006–2011) Owner's Manual / Instruments and Controls / Daytime Running Lights

With the headlight switch in the off or the high beam position, the high beam headlights and the high beam indicator come on with reduced brightness when you turn the ignition switch to the ON (II) position and release the parking brake. They remain on until you turn the ignition switch off, even if you set the parking brake.

The headlights revert to normal operation when you turn them on with the switch.

READ NEXT:

 Instrument Panel Brightness

You can change the instrument panel brightness only when the light switch is on. Turn the knob on the lower part of the instrument panel to adjust the brightness. You will hear a beep wh

 HazardWarning Button

Push the button between the center vents to turn on the hazard warning lights (four-way flashers). This causes all four outside turn signals and both indicators in the instrument panel t

 Rear Window Defogger

The rear window defogger will clear fog, frost, and thin ice from the window. Push the defogger button to turn it on and off. The indicator in the button comes on to show the defogger is

SEE MORE:

 Ignition Switch

The ignition switch has four positions: LOCK (0), ACCESSORY (I), ON (II), and START (III). LOCK (0) - You can insert or remove the key only in this position. To turn the key, the shift lever must be in Park, and you must push the key in slightly. If the front wheels are turned, the

 Propeller Shaft

Propeller Shaft Inspection Universal Joint and Boots 1. Set the parking brake, then shift the transmission to the N position. 2. Raise the vehicle on a lift. 3. Check the center support bearing (A) for excessive play or rattle. If the center support has excessive play or rattle, replace the propel

© 2016-2025 Copyright www.hcrv.net