Honda CR-V: Instrument Panel Brightness
Honda CR-V (2006–2011) Owner's Manual / Instruments and Controls / Instrument Panel Brightness
You can change the instrument panel brightness only when the light switch is on.
Turn the knob on the lower part of the instrument panel to adjust the brightness.
You will hear a beep when maximum or minimum brightness is reached.
To reduce glare at night, the
instrument panel illumination dims
when you turn the light switch to
or 
.
Turning the select/
reset knob fully to the right until you
hear a beep will cancel the reduced
brightness.
READ NEXT:
HazardWarning Button
Push the button between the center
vents to turn on the hazard warning
lights (four-way flashers). This
causes all four outside turn signals
and both indicators in the instrument
panel t
Rear Window Defogger
The rear window defogger will clear
fog, frost, and thin ice from the
window. Push the defogger button to
turn it on and off. The indicator in
the button comes on to show the
defogger is
Parking Brake
To apply the parking brake, push the
pedal down with your foot. To
release it, push on the pedal again.
The parking brake indicator on the
instrument panel should go out when
the parking
SEE MORE:
Replacing a Front Turn Signal Light Bulb
1. Open the hood.
To change the turn signal bulb on
the driver’s side, remove the
engine coolant reserve tank by
pulling it out of its holder.
2. Remove the socket from the
headlight assembly by turning it
one-quarter turn counterclockwise.
3. Pull the bulb straight out of its
s
ATF Cooler
ATF Cooler Cleaning
Special Tools Required
ATF cooler cleaner GHTTTCF6H
Magnetic nonbypass spin-on filter GTHGNBP2
These special tools are available through the Honda
Tool and Equipment Program 1-888-424-6857.
Before installing an overhauled or remanufactured
automatic transmission, you must
© 2016-2025 Copyright www.hcrv.net
