Honda CR-V: If the EngineWon’t Start

Diagnosing why the engine won’t start falls into two areas, depending on what you hear when you turn the ignition switch to the START (III) position:

You hear nothing, or almost nothing. The engine’s starter motor does not operate at all, or operates very slowly.

You can hear the starter motor operating normally, or the starter motor sounds like it is spinning faster than normal, but the engine does not start up and run.

READ NEXT:

 Nothing Happens or the Starter Motor Operates Very Slowly

When you turn the ignition switch to the START (III) position, you do not hear the normal noise of the engine trying to start. You may hear a clicking sound, a series of clicks, or nothing a

 The Starter Operates Normally

In this case, the starter motor’s speed sounds normal, or even faster than normal, when you turn the ignition switch to the START (III) position, but the engine does not run. Are you using

 Jump Starting

Although this seems like a simple procedure, you should take several precautions. A battery can explode if you do not follow the correct procedure, seriously injuring anyone nearby. Ke

SEE MORE:

 To Play a CD

To play CDs, the ignition switch must be in the ACCESSORY (I) or ON (II) position. You operate the CD changer with the same controls used for the indash disc player or the radio. To select the CD changer, touch the CDC icon. The disc and track numbers are displayed. The system will

 Front Driveshaft Reassembly

Exploded View NOTE: Refer to the Exploded View as needed during this procedure. Inboard Joint Side 1. Wrap the splines with vinyl tape (A) to prevent damaging to the inboard boot. 2. Install the inboard boot onto the drives haft, then remove the vinyl tape. Be careful not to damage the inboard boo

© 2016-2025 Copyright www.hcrv.net