Honda CR-V: Electronic Throttle Control System
Honda CR-V (2006–2011) Service Manual / Fuel and Emissions / Electronic Throttle Control System
Component Location Index
- ELECTRONIC THROTTLE
CONTROL SYSTEM (ETCS)
CONTROL RELAY (RELAY SOCKET F) - POWERTRAIN CONTROL
MODULE (PCM)
- General Troubleshooting Information
- Replacement
- THROTTLE ACTUATOR and THROTTLE POSITION (TP) SENSOR
-
ACCELERATOR PEDAL MODULE
-
Removal/Installation
-
-
ACCELERATOR PEDAL POSITION (APP) SENSOR
-
Signal Inspection
-
READ NEXT:
DTC P0122: TP Sensor A Circuit Low Voltage
NOTE: Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
1. Turn the ignition switch ON (II).
2. Clear the DTC with the HD
DTC P1658: ETCS Control Relay ON
Malfunction
NOTE: Before you troubleshoot. record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
1. Turn the ignition switch ON (II).
2. Do the ETCS TEST in the
SEE MORE:
Damper/Spring
Damper/Spring Removal and Installation
Removal
1. Turn the ignition switch ON (II), then turn on the
windshield wipers. Turn the ignition switch off
when the wipers are near the A-pillars.
2. Raise the front of the vehicle, and support it with safety stands in the
proper locations.
3. Remove th
DTC Troubleshooting
DTC B1028: Rear Window Wiper Motor (As)
Signal Error
NOTE: If you are troubleshooting multiple DTCs, be
sure to follow the instructions in B-CAN System
Diagnosis Test Mode A.
1. Clear the DTCs with the HDS.
2. Turn the. ignition switch OFF, and then back ON (II).
3. Operate the rear window wiper f
© 2016-2025 Copyright www.hcrv.net
