Honda CR-V: Electronic Throttle Control System
Honda CR-V (2006–2011) Service Manual / Fuel and Emissions / Electronic Throttle Control System
Component Location Index
- ELECTRONIC THROTTLE
CONTROL SYSTEM (ETCS)
CONTROL RELAY (RELAY SOCKET F) - POWERTRAIN CONTROL
MODULE (PCM)
- General Troubleshooting Information
- Replacement
- THROTTLE ACTUATOR and THROTTLE POSITION (TP) SENSOR
-
ACCELERATOR PEDAL MODULE
-
Removal/Installation
-
-
ACCELERATOR PEDAL POSITION (APP) SENSOR
-
Signal Inspection
-
READ NEXT:
DTC P0122: TP Sensor A Circuit Low Voltage
NOTE: Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
1. Turn the ignition switch ON (II).
2. Clear the DTC with the HD
DTC P1658: ETCS Control Relay ON
Malfunction
NOTE: Before you troubleshoot. record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
1. Turn the ignition switch ON (II).
2. Do the ETCS TEST in the
SEE MORE:
Towing Equipment and Accessories
Towing can require a variety of
equipment, depending on the size of
your trailer, how it will be used, how
much load you are towing, and
where you tow.
Discuss your needs with your trailer
sales or rental agency, and follow the
guidelines in this section. Also make
sure that all equip
Symptom Troubleshooting
Hard Steering
1. Check the power assist.
Is the initial turning load more than 34 N (3.5 kgf,
7.7 Ibf) ?
YES-Go to step 2.
NO-Power assist is OK.
2. Connect the P/S joint adapter (pump), P/S joint
adapter (hose), and P/S pressure gauge T/N 07406-
0010001 (see page 17-9), T/N 07406-001000A or T/N
© 2016-2025 Copyright www.hcrv.net
