Honda CR-V: EVAP System
Honda CR-V (2006–2011) Service Manual / Fuel and Emissions / EVAP System
Component Location Index
- EVAPORATIVE EMISSION (EVAP)
CANISTER PURGE VALVE
- Replacement
- POWERTRAIN CONTROL MODULE (PCM)
- General Troubleshooting Information
- Replacement
- FUEL TANK VAPOR CONTROL VALVE
- FUEL FILL CAP
- FUEL TANK PRESSURE
(FTP) SENSOR
- Replacement
- EVAPORATIVE EMISSION
(EVAP) CANISTER
- Replacement
- EVAPORATIVE EMISSION (EVAP)
CANISTER VENT SHUT VALVE
- Replacement
READ NEXT:
DTC P0443: EVAP Canister Purge Valve
Circuit Malfunction
Special Tools Required
Vacuum pump/gauge, 0-30 in.Hg, Snap-on YA4000A
or equivalent, commercially available.
NOTE: Before you troubleshoot, record all freeze data
and any on-board snapshot, and revie
DTC P0451: FTP Sensor Range/Performance
Problem
NOTE:
Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
If DTC P2422 is stored at the same time as DTC P0451,
trouble
SEE MORE:
DTC Troubleshooting
DTC B1000: Communication Bus Line Error
(Bus-off)
1. Clear the DTCs with the HDS.
2. Turn the ignition switch OFF, and then back ON (II).
3. Wait for 6 seconds or more.
4. Check for DTCs with the HDS.
Is DTCs B1000 and/or B1008 and B1011
indicated?
YES-Go to step 5.
NO-Intermittent failure, the
Fuel and Emissions Systems
Special Tools
Fuel Sender Wrench
Fuel Pressure Gauge Attachment Set
Vacuum/Pressure Gauge, 0-4 in.Hg
Pressure Gauge Adapter
Oil Pressure Hose
A/T Pressure Hose
A/T Low Pressure Gauge W/Pane
A/T Pressure Hose, 2,210 mm
A/T Pressure Hose, Adapter
Fuel Pressure Gauge
© 2016-2025 Copyright www.hcrv.net
