Honda CR-V: Fan, Fan Motor, Shroud Removal and Installation

Honda CR-V (2006–2011) Service Manual / Engine Cooling / Cooling System / Fan, Fan Motor, Shroud Removal and Installation

Removal

1. Remove the hood support rod, then use it as shown to prop the hood in the wide-open position.

Honda CR-V. Cooling System

2. Remove the bulkhead cover.

3. Disconnect the fan motor connectors (A) and hood switch connector (B), then remove the harness clips (C).

Honda CR-V. Cooling System

4. Remove the radiator upper brackets (A), then remove the front bulkhead (B).

Honda CR-V. Cooling System

5. Remove the condenser fan shroud assembly (A), then remove the radiator fan shroud assembly (B) from condenser fan shroud side.

Honda CR-V. Cooling System

6. Disassemble the fan shrouds.

Honda CR-V. Cooling System

Installation

1. Assemble the fan shrouds.

Honda CR-V. Cooling System

2. Install the radiator fan shroud assembly (A), then install the condenser fan shroud assembly (B).

Honda CR-V. Cooling System

3. Install the front bulkhead (A), then install the radiator upper brackets (B).

Honda CR-V. Cooling System

4. Apply body paint to the bulkhead mounting bolts.

5. Connect the fan motor connectors (A) and hood switch connector (B), then install the harness clips (C).

Honda CR-V. Cooling System

6. Remove the bulkhead cover.

READ NEXT:

 Radiator Replacement

For Japan-produced Model 1. Drain the engine coolant. 2. Remove the hood support rod, then use it as shown to prop the hood in the wide-open position. 3. Remove the bulkhead cover. 4. Remove the co

 Fan Controls

Component Location Index RADIATOR FAN RELAY A/C CONDENSER FAN RELAY FAN CONTROL RELAY A/C CONDENSER FAN ASSEMBLY RADIATOR FAN ASSEMBLY ENGINE COOLANT TEMPERATURE (ECT) SENSOR 1 E

 Fuel and Emissions

SEE MORE:

 Introduction

How to Use This Manual This manual is divided into multiple sections. The first page of each section is marked with a black tab that lines up with its corresponding thumb index tab on this page and the back cover. You can quickly find the first page of each section without looking through a full ta

 DTC P0137: Secondary HO2S (Sensor 2) Circuit Low Voltage

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the ignition switch ON (II). 2. Clear the DTC with the HDS. 3. Start the engine. Hold the engine speed at 3,000 rpm without load (in Park or neutral) until t

© 2016-2026 Copyright www.hcrv.net