Honda CR-V: Electronic Throttle Control System
Honda CR-V (2006–2011) Service Manual / Fuel and Emissions / Electronic Throttle Control System
Component Location Index
- ELECTRONIC THROTTLE
CONTROL SYSTEM (ETCS)
CONTROL RELAY (RELAY SOCKET F) - POWERTRAIN CONTROL
MODULE (PCM)
- General Troubleshooting Information
- Replacement
- THROTTLE ACTUATOR and THROTTLE POSITION (TP) SENSOR
-
ACCELERATOR PEDAL MODULE
-
Removal/Installation
-
-
ACCELERATOR PEDAL POSITION (APP) SENSOR
-
Signal Inspection
-
READ NEXT:
DTC P0122: TP Sensor A Circuit Low Voltage
NOTE: Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
1. Turn the ignition switch ON (II).
2. Clear the DTC with the HD
DTC P1658: ETCS Control Relay ON
Malfunction
NOTE: Before you troubleshoot. record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
1. Turn the ignition switch ON (II).
2. Do the ETCS TEST in the
SEE MORE:
Replacing a High-mount Brake Light Bulb
1. Open the tailgate.
Unlatch the top of the cover by
pulling back on it with your hands.
2. Place a cloth on the side edge of
the cover to prevent scratches.
Remove the cover by carefully
prying on the edge with a small
flat-tip screwdriver and pulling the
cover off.
3. Remove the
VSA (Vehicle Stability Assist) System Components
Component Location Index
VSA MODULATOR-CONTROL UNIT
Removal and Installation
UNDER-HOOD FUSE/RELAY BOX
DATA LINK
CONNECTOR (DLC)
STEERING ANGLE SENSOR
Replacement
VSA OFF SWITCH
Test
RIGHT-REAR WHEEL SENSOR
Replacement
HUB BEARING UNIT
(MAGNETIC ENCODER)
Replace
© 2016-2025 Copyright www.hcrv.net
