Honda CR-V: Replacing a High-mount Brake Light Bulb

1. Open the tailgate.
Unlatch the top of the cover by
pulling back on it with your hands.

2. Place a cloth on the side edge of
the cover to prevent scratches.
Remove the cover by carefully
prying on the edge with a small
flat-tip screwdriver and pulling the
cover off.
3. Remove the socket from the light
assembly by turning it one-quarter
turn counterclockwise.

4. Pull the bulb straight out of its
socket. Push the new bulb straight
into the socket until it bottoms.
5. Press the brake pedal to make
sure the new bulb is working.
6. Put the socket back into the light
assembly, and turn it clockwise to
lock it in place.
7. Put the cover back on the light
assembly. Push it in until it locks
in place.
READ NEXT:
Dirt build-up in the loops of the seat
belt anchors can cause the belts to
retract slowly. Wipe the insides of
the loops with a clean cloth
dampened in mild soap and warm
water or isopropy
The floor mats that came with your
vehicle hook over the floor mat
anchors. This keeps the floor mats
from sliding forward, possibly
interfering with the pedals, or
backwards, making the f
Your vehicle is equipped with an
antenna at the rear of the roof . Bef ore
using a ‘‘drive-through’’ car wash,
remove the antenna by unscrewing it by
hand. This prevents the antenna
SEE MORE:
Do not attempt to deactivate your
airbags. Together, airbags and
seat belts provide the best
protection.
Do not tamper with airbag
components or wiring for any
reason. Tampering could cause
the airbags to deploy, possibly
causing very serious injury.
Do not expose the front passenger
Press the SOUND (TUNE) knob
repeatedly to display the BASS,
TREBLE, FADER, BALANCE, and
SVC (speed-sensitive volume
compensation) settings.
BASS - Adjusts the bass.
TREBLE - Adjusts the treble.
FADER - Adjusts the front-to-back strength of the sound.
BALANCE - Adjusts the
side-toside s
© 2016-2025 Copyright www.hcrv.net
