Honda CR-V: Turn Signal/Hazard Flasher
Component Location Index

- TURN SIGNAL SWITCH
(Built into the combination light switch)
- TURN SIGNAL INDICATORS
- HAZARD WARNING SWITCH
- MICU (Built into the under-dash fuse/relay box)
Circuit Diagram


MICU Input Test
NOTE: Before testing, troubleshoot the B-CAN System Diagnosis Test Mode A.
1. Check the No. 10 (7.5 A) fuse in the under-dash fuse/relay box. lf the fuse
is blown, replace it and go to step 2.
2. Disconnect the under-dash fuse/relay box connectors E, F, G, P, Q, R, S, and
T.
NOTE: All connector views are wire side of female terminals.


3. Inspect the connector and socket terminals to be sure they are all making
good contact.
- If the terminals are bent, loose or corroded, repair them as necessary
and recheck the system.
- If the terminals look OK, go to step 4.
4. With the connectors still disconnected, make these input tests at the
appropriate connector.
- If any test indicates a problem, find and correct the cause, then
recheck the system.
- If all the input tests prove OK, go to step 5.

5. Reconnect the connectors to the under-dash fuse/relay box, and make these
input tests at the connectors.
- If any test indicates a problem, find and correct the cause, then
recheck the system.
- If all the input tests prove OK, the MICU must be faulty; replace the
under-dash fuse/relay box.

Hazard Warning Switch
Test/Replacement
1. Remove the center vent.
2. Remove the hazard warning switch (A).

3. Check for continuity between the terminals in each
switch position according to the table.

4. If the continuity is not as specified, replace the
hazard warning switch.
READ NEXT:
Component Location Index
With moon roof
INDIVIDUAL MAP LIGHTS
INTERIOR LIGHT SWITCH
(Built into the moonroof switch)
AMBIENT LIGHT
(Built into the moonroof switch)
CEILING LIGHT
CARGO AREA LI
Component Location Index
With moonroof
INDIVIDUAL MAP LIGHTS
IGNITION KEY SWITCH
IGNITION KEY LIGHT
CEILING LIGHT
CARGO AREA LIGHT
RIGHT REAR DOOR SWITCH
FRONT PASSENGER'S
DOOR SWITCH
LEFT
Component Location Index
POWER WINDOW MASTER SWITCH
(With built-in control unit)
FRONT PASSENGER'S POWER WINDOW SWITCH
FRONT PASSENGER'S POWER WINDOW MOTOR
RIGHT REAR POWER WINDOW SWITCH
RIGHT
SEE MORE:
You can use the preset buttons while
a disc is playing to select passages
and change tracks (files inMP3 or
WMA mode). Each preset button’s
function is shown on the bottom of
the screen.
You can also select an icon with the
joystick.Move it to left, right, up, or
down to change
Your vehicle has the auxiliary input
jack on the front panel, on the center
table, or in the console compartment,
depending on models. The system
will accept auxiliary input from
standard audio accessories.
When a compatible audio unit is
connected to the jack, press the AUX
butto
© 2016-2025 Copyright www.hcrv.net
