Honda CR-V: Replacement Parts
Honda CR-V (2006–2011) Owner's Manual / Technical Information / Emissions Controls / Replacement Parts
The emissions control systems are designed and certified to work together in reducing emissions to levels that comply with the Clean Air Act. To make sure the emissions remain low, you should use only new Honda replacement parts or their equivalent for repairs. Using lower quality partsmay increase the emissions from your vehicle.
The emissions control systems are covered by warranties separate from the rest of your vehicle. Read your warranty manual for more information.
READ NEXT:
ThreeWay Catalytic Converter
The three way catalytic converter
contains precious metals that serve
as catalysts, promoting chemical
reactions to convert the exhaust
gasses without affecting the metals.
The catalytic conv
Emissions Testing
Testing of Readiness Codes
If you take your vehicle for an
emissions test shortly after the
battery has been disconnected or
gone dead, it may not pass the test.
This is because of certain ‘
SEE MORE:
VSA (Vehicle Stability Assist) System Components
Component Location Index
VSA MODULATOR-CONTROL UNIT
Removal and Installation
UNDER-HOOD FUSE/RELAY BOX
DATA LINK
CONNECTOR (DLC)
STEERING ANGLE SENSOR
Replacement
VSA OFF SWITCH
Test
RIGHT-REAR WHEEL SENSOR
Replacement
HUB BEARING UNIT
(MAGNETIC ENCODER)
Replace
Transmission Removal/Installation
Transmission Removal
Special Tools Required
Engine hanger adapter VSB02C000015
CR-V engine hanger adapter VSB02C000032
Front subframe adapter VSB02C000016
Engine support hanger, A and Reds AAR-T-12566
These special tools are available through the Honda
Tool and Equipment Program 1-888-424-6857
© 2016-2025 Copyright www.hcrv.net
