Honda CR-V: Rearview Camera and Monitor

Honda CR-V (2006–2011) Owner's Manual / Features / Rearview Camera and Monitor

On EX-L model with navigation system

Whenever you shift to reverse (R)

Whenever you shift to reverse (R) with the ignition switch in the ON (II) position, the rearview is shown on the navigation system screen.

For the best picture, always keep the rearview camera clean, and do not cover the camera lens. To avoid scratching the lens when you clean it, use a moist, soft cloth.

When in reverse, the touch screen and navigation system ‘‘hard’’ buttons are locked out, except the ‘‘ZOOM’’ button. Touching the ‘‘ or ‘‘  ’’ button allows you to ’’ or ‘‘ adjust ’’ button allows you to adjust the brightness of the rearview camera image.

The camera brightness cannot be

The camera brightness cannot be adjusted by voice control.

Since the rearview camera display area is limited, you should always back up slowly and carefully, and look behind you for obstacles.

READ NEXT:

 Cruise Control

Cruise control allows you to maintain a set speed above 25 mph (40 km/h) without keeping your foot on the accelerator pedal. It should be used for cruising on straight, open highways. It is

 Using the Cruise Control

1. Push the CRUISE button on the steering wheel. The CRUISE MAIN indicator on the instrument panel comes on. The cruise control systemcan be left on, even when it is not in use. 2. Acceler

 Changing the Set Speed

You can increase the set cruising speed in any of these ways: Press and hold the RES/ACCEL button. When you reach the desired cruising speed, release the button. To increase the speed in ver

SEE MORE:

 Carrying Cargo on the Dual Deck Cargo Shelf

If equipped On U.S. model is shown Do not put any items on the dual deck cargo shelf that could block your view or be thrown around the vehicle during a crash. Do not use the dual deck cargo shelf if the rear seats are folded down. Do not exceed the dual deck cargo shelf load limit o

 Connectors and Harnesses

Connector Index Identification numbers have been assigned to in-line connectors, junction connectors, and terminals. The number is preceded by the letter ºC" for connectors "G" for ground terminals or "T" for non-ground terminals. * 1. With seat heater * 2: Without seat heater Connector to Harne

© 2016-2025 Copyright www.hcrv.net