Honda CR-V: Using the Cruise Control

1. Push the CRUISE button on the

1. Push the CRUISE button on the steering wheel. The CRUISE MAIN indicator on the instrument panel comes on.

The cruise control systemcan be left on, even when it is not in use.

2. Accelerate to the desired cruising speed above 25 mph (40 km/h).

3. Press and release the SET/ DECEL button on the steering wheel. The CRUISE CONTROL indicator on the instrument panel comes on to show the system is now activated.

Cruise control may not hold the set speed when you are going up and down hills. If your vehicle speed increases going down a hill, use the brakes to slow down. This will cancel the cruise control. To resume the set speed, press the RES/ACCEL button.

The CRUISE CONTROL indicator on the instrument panel will come back on.

READ NEXT:

 Changing the Set Speed

You can increase the set cruising speed in any of these ways: Press and hold the RES/ACCEL button. When you reach the desired cruising speed, release the button. To increase the speed in ver

 Canceling Cruise Control

You can cancel cruise control in any of these ways: Tap the brake pedal. Push the CANCEL button on the steering wheel. Push the CRUISE button on the steering wheel.

 Resuming the Set Speed

When you push the CANCEL button, or tap the brake pedal, the system remembers the previously set speed. To return to that speed, accelerate to above 25 mph (40 km/h), and then press and relea

SEE MORE:

 Differential Reassembly

Exploded View Special Tools Required Holder handle 07JAB-001020A Companion flange holder 07RAB-TB4010B 1. Apply differential fluid to the rubber pinion of the ATF strainer (A), then install the ATF strainer, the magnet (B), the dowel pins (C), and the oil pump pin (D), in the differential carri

 Valve Body

Valve Body and ATF Strainer Removal NOTE: The illustration shows the 4WD transmission; the 2WD is similar. 1. Remove the ATF feed pipes (A) and ATF joint pipes (B). 2. Remove the ATF strainer (C) (two bolts), 3. Remove the regulator valve body (D) (eight bolts), 4. Remove the stator shaft (E) and

© 2016-2025 Copyright www.hcrv.net