Honda CR-V: Relay and Control Unit Locations
Honda CR-V (2006–2011) Service Manual / Body Electrical / Relay and Control Unit
Locations
Engine Compartment
- VSA MODULATOR-CONTROL UNIT
- AUXILIARY UNDER-HOOD RELAY BOX
- POWER MIRROR DEFOGGER RELAY
- PCM
- RADIATOR FAN RELAY
- ELECTRONIC THROTTLE CONTROL SYSTEM (ETCS) CONTROL RELAY
- ELD UNIT
- PGM-FI MAIN RELAY 1 (FI MAIN)
- UNDER-HOOD FUSE/RELAY BOX
- FAN CONTROL RELAY
- BLOWER MOTOR RELAY
- REAR WINDOW WIPER MOTOR RELAY
- PGM-FI SUBRELAY
- REAR WINDOW DEFOGGER RELAY
- IGNITION COIL RELAY
- A/C COMPRESSOR CLUTCH RELAY
Dashboard
- GAUGE CONTROL MODULE
- XM RECEIVER (With XM radio)
- CARGO AREA ACCESSORY POWER SOCKET RELAY
- CONSOLE ACCESSORY POWER SOCKET RELAY
- FRONT ACCESSORY POWER SOCKET RELAY
- TPMS CONTROL UNIT
- NAVIGATION DISPLAY UNIT or AUDIO UNIT (Without navigation system)
- IMMOBILIZER-KEYLESS CONTROL UNIT (Built-in receiver)
- HVAC CONTROL UNIT
- SRS UNIT
Driver's Door
- POWER WINDOW MASTER SWITCH (Has built-in control unit)
- MOONROOF CONTROL UNIT/MOTOR
Seat
- DRIVER'S SEAT
- DRIVER'S SEAT HEATER
HIGH RELAY (4P)
DRIVER'S SEAT HEATER LOW RELAY (5P) - FRONT PASSENGER'S SEAT
- FRONT PASSENGER'S SEAT
HEATER HIGH RELAY (4P)
FRONT PASSENGER'S SEAT HEATER LOW RELAY (5P)
READ NEXT:
Connectors and Harnesses
Connector Index
Identification numbers have been assigned to in-line connectors, junction
connectors, and terminals. The number is preceded by the letter ºC" for
connectors "G" for ground terminals
Under-hood/dash Fuse/Relay Box
Under-hood Fuse/Relay Box
Removal and Installation
Removal
1. Make sure you have the anti-theft codes for the
audio and navigation system. If equipped with XM
radio, write down the XM radio presets.
Battery
WARNING
A battery can explode if you do not follow the
proper procedure, causing serious injury to anyone
nearby. Follow all procedures carefully and keep
sparks and open flames away from the battery.
SEE MORE:
DTC 22-3x ("x" can be 0 thru 9 or A thru F):
Short to Another Wire or Decreased
Resistance in Front Passenger's Seat Belt
Tensioner
Special Tools Required
SRS inflator simulator 07SAZ-TB4011A
SRS simulator lead K 070AZ-SNAA200
NOTE: Before doing this troubleshooting procedure,
review SRS Precautions and Procedures.
1. Erase the DTC memory.
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for ab
To Change or Select Files
Use the SKIP button while an iPod is
playing to change files.
SKIP - Each time you press and
release
(preset 6), the player
skips forward to the beginning of the
next file. Press and release
(preset 5), to skip backward to
the beginning of the current file.
Press it again to skip t
© 2016-2025 Copyright www.hcrv.net
