Honda CR-V: Parking

Always use the parking brake when you park your vehicle. Make sure the parking brake is set firmly, or your vehicle may roll if it is parked on an incline.

Set the parking brake before you put the transmission in Park. This keeps the vehicle from moving and putting pressure on the parking mechanism in the transmission.

READ NEXT:

 Parking Tips

Make sure the moonroof (if equipped) and the windows are closed. Turn off the lights. Place any packages, valuables, etc. in the cargo area or take them with you. Lock the doors and the tail

 Braking System

Your vehicle is equipped with disc brakes at all four wheels. A power assist helps reduce the effort needed on the brake pedal. The anti-lock brake system (ABS) helps you retain steering con

 Braking System Design

The hydraulic system that operates the brakes has two separate circuits. Each circuit works diagonally across the vehicle (the left-front brake is connected with the right-rear brake, etc.).

SEE MORE:

 DLC Circuit Troubleshooting

NOTE: Make sure the HDS and the DLC cable of the HDS is not defective. 1. Turn the ignition switch OFF. 2. Connect the HDS to the DLC. NOTE: Make sure the HDS is properly connected to the DLC. 3. Turn the ignition switch ON (II). and read the HDS. Does the HDS identify the vehicle? YES-Go to ste

 DTC P0137: Secondary HO2S (Sensor 2) Circuit Low Voltage

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the ignition switch ON (II). 2. Clear the DTC with the HDS. 3. Start the engine. Hold the engine speed at 3,000 rpm without load (in Park or neutral) until t

© 2016-2025 Copyright www.hcrv.net