Honda CR-V: EVAP System
Honda CR-V (2006–2011) Service Manual / Fuel and Emissions / EVAP System
Component Location Index
- EVAPORATIVE EMISSION (EVAP)
CANISTER PURGE VALVE
- Replacement
- POWERTRAIN CONTROL MODULE (PCM)
- General Troubleshooting Information
- Replacement
- FUEL TANK VAPOR CONTROL VALVE
- FUEL FILL CAP
- FUEL TANK PRESSURE
(FTP) SENSOR
- Replacement
- EVAPORATIVE EMISSION
(EVAP) CANISTER
- Replacement
- EVAPORATIVE EMISSION (EVAP)
CANISTER VENT SHUT VALVE
- Replacement
READ NEXT:
DTC P0443: EVAP Canister Purge Valve
Circuit Malfunction
Special Tools Required
Vacuum pump/gauge, 0-30 in.Hg, Snap-on YA4000A
or equivalent, commercially available.
NOTE: Before you troubleshoot, record all freeze data
and any on-board snapshot, and revie
DTC P0451: FTP Sensor Range/Performance
Problem
NOTE:
Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
If DTC P2422 is stored at the same time as DTC P0451,
trouble
SEE MORE:
System Description
Electronic Control System
The functions of the fuel and emission control systems are managed by the
powertrain control module (PCM).
Self-diagnosis
The PCM detects a failure of a signal from a sensor or from another control
unit and stores a Temporary DTC or a DTC.
Depending on the failure, a DTC
DTC P0457: EVAP System Leak Detected/Fuel
Fill Cap Loose or Missing
NOTE: Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
1. Check the fuel fill cap (the cap must say "Tighten to
click"). It should turn 1/4 turn after it's tight, then it
clicks.
Is the correct fuel fill cap installed a
© 2016-2025 Copyright www.hcrv.net
