Honda CR-V: EVAP System
Honda CR-V (2006–2011) Service Manual / Fuel and Emissions / EVAP System
Component Location Index
- EVAPORATIVE EMISSION (EVAP)
CANISTER PURGE VALVE
- Replacement
- POWERTRAIN CONTROL MODULE (PCM)
- General Troubleshooting Information
- Replacement
- FUEL TANK VAPOR CONTROL VALVE
- FUEL FILL CAP
- FUEL TANK PRESSURE
(FTP) SENSOR
- Replacement
- EVAPORATIVE EMISSION
(EVAP) CANISTER
- Replacement
- EVAPORATIVE EMISSION (EVAP)
CANISTER VENT SHUT VALVE
- Replacement
READ NEXT:
DTC P0443: EVAP Canister Purge Valve
Circuit Malfunction
Special Tools Required
Vacuum pump/gauge, 0-30 in.Hg, Snap-on YA4000A
or equivalent, commercially available.
NOTE: Before you troubleshoot, record all freeze data
and any on-board snapshot, and revie
DTC P0451: FTP Sensor Range/Performance
Problem
NOTE:
Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
If DTC P2422 is stored at the same time as DTC P0451,
trouble
SEE MORE:
Differential Reassembly
Exploded View
Special Tools Required
Holder handle 07JAB-001020A
Companion flange holder 07RAB-TB4010B
1. Apply differential fluid to the rubber pinion of the
ATF strainer (A), then install the ATF strainer, the
magnet (B), the dowel pins (C), and the oil pump
pin (D), in the differential carri
Using a Booster Seat
A child who has outgrown a forwardfacing
child seat should ride in a
back seat and use a booster seat
until the lap/shoulder belt fits them
properly without the booster.
Some states, Canadian provinces and
territories also require children to
use a booster seat until they reach a
© 2016-2025 Copyright www.hcrv.net
