Honda CR-V: VTEC/VTC
Honda CR-V (2006–2011) Service Manual / Fuel and Emissions / VTEC/VTC
Component Location Index
-
ROCKER ARM OIL CONTROL VALVE
-
Removal/Installation
-
-
ROCKER ARM OIL PRESSURE SWITCH
-
Removal/Installation
-
-
CAMSHAFT POSITION (CMP) SENSOR A (INTAKE)
-
Replacement
-
-
POWERTRAIN CONTROL MODULE (PCM)
-
General Troubleshooting Information,
Replacement
-
-
VTC STRAINER
-
VTC OIL CONTROL SOLENOID VALVE
-
Removal/Installation
-
READ NEXT:
DTC P0010: VTC Oil Control Solenoid Valve
Malfunction
NOTE: Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
1. Turn the ignition switch ON (II).
2. Clear the DTC with the H
DTC P1009: VTC Advance Malfunction
NOTE:
Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
If DTC P0341 is stored at the same time as DTC P1009,
trouble
SEE MORE:
DTC P0716: Problem in Input Shaft
(Mainshaft) Speed Sensor Circuit
DTC P0716: Problem in Input Shaft
(Mainshaft) Speed Sensor Circuit
DTC P0717: Problem in Input Shaft
(Mainshaft) Speed Sensor Circuit (No Signal
Input)
NOTE:
Before you troubleshoot, record all freeze data and any on-board
snapshot, and review General Troubleshooting Information.
This code is c
DLC Circuit Troubleshooting
NOTE: Make sure the HDS and the DLC cable of the
HDS is not defective.
1. Turn the ignition switch OFF.
2. Connect the HDS to the DLC.
NOTE: Make sure the HDS is properly connected to
the DLC.
3. Turn the ignition switch ON (II). and read the HDS.
Does the HDS identify the vehicle?
YES-Go to ste
© 2016-2025 Copyright www.hcrv.net
