Honda CR-V: Door Lower Trim Replacement
NOTE:
- Take care not to scratch the door.
- Put on gloves to protect your hands.
1. Remove these items:
- Door panel, front , rear.
- Door speaker, front, rear.
2. From the front or the rear door, remove the screw.

3. Using a utility knife, carefully cut the double-sided
adhesive tape (A) along the edge of the door lower
trim (B).
Front door

Rear door

4. With the help of an assistant, slide the door lower
trim (A) rearward, and remove it. The clips (B, C)
stay in the body. Turn the clips (B) 45 º
counterclockwise, and remove them.
Front door

Rear door

5. Check if the clips are damaged or stress-whitened,
and if necessary, replace them with new ones.
6. Install the clips on the trim.
7. Scrape off the remaining double-sided adhesive
tape from the trim and door, then clean the trim
and door surfaces with a sponge dampened in
isopropyl alcohol.
8. Apply primer to the area where the panel will be
applied.
9. Attach the double-sided adhesive tape (A) to the
trim (B), and fold the edge of each adhesive
backing from the double-sided adhesive tape.
Front door

Rear door

10. Hold the trim (A) up, and fit all the clips (B, C) into
the holes in the door, then push on the trim until
the clips snap into place.
Front door

Rear door

11. Carefully pull the adhesive backing (D) away, and
push the trim into place securely.
12. Set the screw into the back of clip, then reinstall the
door speaker and the door panel.
READ NEXT:
Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and
Equipment Program; call 888-424-6857
NOTE:
Put on gloves to protect your hands.
Take care not t
Front Inner Fender Replacement
NOTE: Take care not to scratch the body.
1. Remove the front wheel arch protector, as needed.
2. Remove the front inner fender (A).
Remove the screws (B, C), and remo
Component Location Index
HOOD OPENER CABLE
Replacement
FUEL FILL DOOR OPENER
Replacement
TAILGATE LATCH
Replacement
FUEL FILL DOOR LATCH
Replacement
FUEL FILL DOOR OPENE
SEE MORE:
This audio system can select and
play the audio files on the iPod with
the same controls used for the indash
disc player. To play an iPod,
connect it to the USB adapter cable
in the upper glove box by using your
dock connector. Press the AUDIO
button beside the screen to show the
aud
If you see an error message in the
display while playing a disc, find the
cause in the chart to the right. If you
cannot clear the error message, take
your vehicle to your dealer.
The chart on the right explains the
error messages you may see in the
display while playing a disc.
If you
© 2016-2025 Copyright www.hcrv.net
