Honda CR-V: If the EngineWon’t Start

Diagnosing why the engine won’t start falls into two areas, depending on what you hear when you turn the ignition switch to the START (III) position:

You hear nothing, or almost nothing. The engine’s starter motor does not operate at all, or operates very slowly.

You can hear the starter motor operating normally, or the starter motor sounds like it is spinning faster than normal, but the engine does not start up and run.

READ NEXT:

 Nothing Happens or the Starter Motor Operates Very Slowly

When you turn the ignition switch to the START (III) position, you do not hear the normal noise of the engine trying to start. You may hear a clicking sound, a series of clicks, or nothing a

 The Starter Operates Normally

In this case, the starter motor’s speed sounds normal, or even faster than normal, when you turn the ignition switch to the START (III) position, but the engine does not run. Are you using

 Jump Starting

Although this seems like a simple procedure, you should take several precautions. A battery can explode if you do not follow the correct procedure, seriously injuring anyone nearby. Ke

SEE MORE:

 EGR Passage Removal and Installation

Removal 1. Drain the engine coolant. 2. Remove the air cleaner housing. 3. Remove the harness holder (A) from the bracket, then remove the harness holder bracket (B). 4. Remove the upper radiator hose (A), heater hose (B), and water bypass hose (C). 5. Remove the air cleaner housing brackets. 6

 Reclining the Front Seats

You can recline the seat-backs on the front seats so they are level with the rear seat cushions, making a large cushioned area. To do this: EX-L and Canadian EX models Only the passenger’s side can be level as follows. 1. Adjust the rear seats as far back as possible. 2. Remove t

© 2016-2025 Copyright www.hcrv.net