Honda CR-V: Detachable Anchor
The seat belt in the rear center seat is equipped with a detachable anchor.
This allows the center seat belt to be unlatched when the rear center seat back is folded down or the right side rear seat is folded forward.
Using the seat belt with the detachable anchor unlatched increases the chance of serious injury or death in a crash.
Before using the seat belt, make sure the detachable anchor is correctly latched.
Pull out the small latch plate and the latch plate from each holding slot in the ceiling, and pull out the seat belt to extend it.
Line up the triangle marks on the small latch plate and anchor buckle when reattaching the belt and buckle.
Tug on the seat belt to verify that the detachable anchor is securely latched. Make sure the seat belt is not twisted.
To unlatch the detachable anchor, insert the latch plate into the slot on the side of the anchor buckle. Store the detachable anchor and seat belt latch plates in the retractor housing.
READ NEXT:
Seat Heaters
If equipped
Both front seats are equipped with
seat heaters. The passenger seat
only has heaters in the seat bottom
because of the side airbag cutoff
system.
The ignition switch must
Power Windows
Turn the ignition switch to the ON
(II) position to raise or lower any
window. To open the window, push
the switch down and hold it. Release
the switch when you want to stop the
window.
Moonroof
If equipped
The moonroof can be tilted up in the
back for ventilation, or it can be slid
back into the roof. Use the switch on
the front ceiling to operate the
moonroof. You must turn the
SEE MORE:
To Stop Playing a Disc
Press the eject button (
) to
remove the disc. If you eject the disc,
but do not remove it from the slot,
the system will automatically reload
the disc after 10 seconds and put it in
pause mode. To begin playing, press
the CD/AUX button.
You can also eject the disc when the
igniti
Shift Lock Release
This allows you to move the shift
lever out of Park if the normal
method of pushing on the brake
pedal and pressing the release
button does not work.
1. Set the parking brake.
2. Remove the key from the ignition
switch.
3. Put a cloth on the edge of the shift
lock release slot cover.
