Honda CR-V: Door Locks

READ NEXT:

 Power Door Locks

To lock all doors and the tailgate, push the top of the master door lock switch on either front door, pull the lock tab rearward on the driver’s door, or use the key on the outside loc

 Auto Door Locking/Unlocking

Your vehicle has customizable settings for the doors and tailgate to automatically lock and unlock. There are default settings for each of these features. You can turn off or change the sett

 Auto Door Locking

The auto door locking feature has three possible settings: The auto door locking is deactivated all the time. The doors and tailgate lock whenever you move the shift lever out of the Park (P

SEE MORE:

 Front Driveshaft Disassembly

Special Tools Required Threaded adapter, 26 x 1.5 mm 07XAC-001030A Slide hammer, 5/8"-18 UNF, commercially available Inboard Joint Side 1. Remove the set ring (A) from the inboard joint. 2. Remove the boot bands. Be careful not to damage the boot. 3. Make marks (A) on each roller (B) and inboa

 Cylinder Head Installation

1. Install a new coolant separator in the engine block whenever the engine block is replaced. 2. Clean the cylinder head and block surface. 3. Install the new cylinder head gasket (A) and dowel pins (B) on the engine block. Always use a new cylinder head gasket. Set the crankshaft to top dead cen

© 2016-2025 Copyright www.hcrv.net