Honda CR-V: EGR Passage Removal and Installation

Honda CR-V (2006–2011) Service Manual / Engine Cooling / Cooling System / EGR Passage Removal and Installation

Removal

1. Drain the engine coolant.

2. Remove the air cleaner housing.

3. Remove the harness holder (A) from the bracket, then remove the harness holder bracket (B).

Honda CR-V. Cooling System

4. Remove the upper radiator hose (A), heater hose (B), and water bypass hose (C).

Honda CR-V. Cooling System

5. Remove the air cleaner housing brackets.

Honda CR-V. Cooling System

6. Disconnect the exhaust gas recirculation (EGR) valve connector.

7. Remove the EGR passage.

Honda CR-V. Cooling System

8. Remove the EGR valve.

Honda CR-V. Cooling System

Installation

1. Install the EGR valve (A) with a new gasket (B).

Honda CR-V. Cooling System

2. Install the EGR passage (A) with a new gasket (B).

Honda CR-V. Cooling System

3. Connect the EGR valve connector.

4. Install the air cleaner housing brackets.

Honda CR-V. Cooling System

5. Install the upper radiator hose (A), heater hose (B), and water bypass hose (C).

Honda CR-V. Cooling System

6. Install the harness holder bracket (A), then install the harness holder (B).

Honda CR-V. Cooling System

7. Install the air cleaner housing.

8. Refill the radiator with engine coolant, and bleed the air from the cooling system with the heater valve open (see step 6).

READ NEXT:

 Fan, Fan Motor, Shroud Removal and Installation

Removal 1. Remove the hood support rod, then use it as shown to prop the hood in the wide-open position. 2. Remove the bulkhead cover. 3. Disconnect the fan motor connectors (A) and hood switch conn

 Radiator Replacement

For Japan-produced Model 1. Drain the engine coolant. 2. Remove the hood support rod, then use it as shown to prop the hood in the wide-open position. 3. Remove the bulkhead cover. 4. Remove the co

 Fan Controls

Component Location Index RADIATOR FAN RELAY A/C CONDENSER FAN RELAY FAN CONTROL RELAY A/C CONDENSER FAN ASSEMBLY RADIATOR FAN ASSEMBLY ENGINE COOLANT TEMPERATURE (ECT) SENSOR 1 E

SEE MORE:

 DTC P0962: Problem in A/T Clutch Pressure Control Solenoid Valve A Circuit

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review General Troubleshooting Information (see page 14-4). This code is caused by an electrical circuit problem and cannot be caused by a mechanical problem in the transmission. 1. Clear the DTC with the HD

 Load Limits

The maximum load for your vehicle is 850 lbs (385 kg) for U.S. vehicles, and 395 kg for Canadian vehicles. This figure includes the total weight of all occupants, cargo, and accessories, and the tongue load if you are towing a trailer. See Tire And Loading Information label attached to

© 2016-2025 Copyright www.hcrv.net