Honda CR-V: DTC Troubleshooting
READ NEXT:
DTC P0010: VTC Oil Control Solenoid Valve
Malfunction
NOTE: Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
1. Turn the ignition switch ON (II).
2. Clear the DTC with the H
DTC P1009: VTC Advance Malfunction
NOTE:
Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
If DTC P0341 is stored at the same time as DTC P1009,
trouble
VTC Oil Control Solenoid Valve Removal/Test/Installation
1. Disconnect the VTC oil control solenoid valve 2P
connector (A).
2. Remove the bolt (B) and the VTC oil control
solenoid valve (C).
3. Check the VTC oil control solenoid valve strainer
for cloggin
SEE MORE:
Driver's Airbag Replacement
Removal
1. Disconnect the negative cable from the battery and
wait at least 3 minutes before beginning work.
2. Remove the access panel (A) from the steering
wheel, then disconnect the driver's airbag 4P
connector (B) and horn switch 1P connector (C)
from the cable reel.
3. Using a TORX T30 bit, r
PGM-FI System
Component Location Index
CAMSHAFT POSITION (CMP)
SENSOR B (EXHAUST)
OUTPUT SHAFT (COUNTERSHAFT)
SPEED SENSOR
POWERTRAIN CONTROL
MODULE (PCM)
ELECTRICAL LOAD
DETECTOR (ELD)
(bottom of fuse/relay box)
A/F SENSOR
(LAF) RELAY
(RELAY SOCKET E)
IGNITION
CO
© 2016-2025 Copyright www.hcrv.net
