Honda CR-V: DTC Troubleshooting

READ NEXT:

 DTC P0010: VTC Oil Control Solenoid Valve Malfunction

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the ignition switch ON (II). 2. Clear the DTC with the H

 DTC P1009: VTC Advance Malfunction

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. If DTC P0341 is stored at the same time as DTC P1009, trouble

 VTC Oil Control Solenoid Valve Removal/Test/Installation

1. Disconnect the VTC oil control solenoid valve 2P connector (A). 2. Remove the bolt (B) and the VTC oil control solenoid valve (C). 3. Check the VTC oil control solenoid valve strainer for cloggin

SEE MORE:

 Power Door Locks

To lock all doors and the tailgate, push the top of the master door lock switch on either front door, pull the lock tab rearward on the driver’s door, or use the key on the outside lock on the driver’s door. Pushing the rear of either master door lock switch will unlock all door

 Emissions Testing

Testing of Readiness Codes If you take your vehicle for an emissions test shortly after the battery has been disconnected or gone dead, it may not pass the test. This is because of certain ‘‘readiness codes’’ that must be set in the onboard diagnostics for the emissions systems

© 2016-2025 Copyright www.hcrv.net