Honda CR-V: DTC Troubleshooting
READ NEXT:
DTC P0010: VTC Oil Control Solenoid Valve
Malfunction
NOTE: Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
1. Turn the ignition switch ON (II).
2. Clear the DTC with the H
DTC P1009: VTC Advance Malfunction
NOTE:
Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
If DTC P0341 is stored at the same time as DTC P1009,
trouble
VTC Oil Control Solenoid Valve Removal/Test/Installation
1. Disconnect the VTC oil control solenoid valve 2P
connector (A).
2. Remove the bolt (B) and the VTC oil control
solenoid valve (C).
3. Check the VTC oil control solenoid valve strainer
for cloggin
SEE MORE:
Brake Pedal Position Switch Signal Circuit Troubleshooting
1. Turn the ignition switch ON (II).
2. Check the BRAKE SWITCH in the DATA LIST with
the HDS.
Does it indicate OFF?
YES-Go to step 3.
NO-Inspect the brake pedal position switch.
3. Press the brake pedal, and check the BRAKE
SWITCH in the DATA LIST with the HDS.
Does it change to ON? YES-The bra
DTC 11, 13, 15, 17: Wheel Sensor (Open/Short
to Body Ground/Short to Power)
1. Turn the ignition switch ON (II).
2. Check for DTCs with the HDS.
Is DTC 87 indicated with DTC 11,13,15, and/or 17
at the same time?
YES-Go to step 9.
NO-Go to step 3.
3. Clear the DTC with the HDS.
4. Turn the ignition switch OFF, then turn it ON (II)
again.
5. Check for DTCs with the HDS.
© 2016-2025 Copyright www.hcrv.net
