Honda CR-V: DTC Troubleshooting
READ NEXT:
DTC P0010: VTC Oil Control Solenoid Valve
Malfunction
NOTE: Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
1. Turn the ignition switch ON (II).
2. Clear the DTC with the H
DTC P1009: VTC Advance Malfunction
NOTE:
Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
If DTC P0341 is stored at the same time as DTC P1009,
trouble
VTC Oil Control Solenoid Valve Removal/Test/Installation
1. Disconnect the VTC oil control solenoid valve 2P
connector (A).
2. Remove the bolt (B) and the VTC oil control
solenoid valve (C).
3. Check the VTC oil control solenoid valve strainer
for cloggin
SEE MORE:
Pump Pressure Test
Pump Pressure Test with T/N 07406-0010001
Special Tools Required
P/S joint adapter (pump) 07ZAK-S7C0100
P/S joint adapter (hose) 07ZAK-S7C0200
P/S pressure gauge 07406-0010001
Check the fluid pressure as follows to determine
whether the trouble is in the pump or steering gearbox.
1. Check the
Knuckle/Hub Bearing Unit Replacement
Exploded View
Hub Bearing Unit Replacement
1. Raise the rear of the vehicle, and support it with safety stands in the
proper locations.
2. Remove the wheel nuts (A) and the rear wheel.
3. Remove the brake hose bracket mounting bolt (A)
from the knuckle.
4. Remove the brake caliper bracket mount
© 2016-2025 Copyright www.hcrv.net
