Honda CR-V manuals

Honda CR-V: Compass Operation

Honda CR-V (2006–2011) Owner's Manual / Features / Compass / Compass Operation

Next to the outside temperature

Next to the outside temperature indicator of the information display, a compass indicates which direction your vehicle is pointed. It indicates eight directions.

N: North
S: South
E: East
W: West
NE: Northeast
NW: Northwest
SE: Southeast
SW: Southwest

For example, when your vehicle is traveling in the north-east direction, the compass shows ‘‘NE’’ in the display.

Compass operation can be affected by driving near power lines or stations, across bridges, through tunnels, over railroad crossings, past large vehicles, or driving near large objects that can cause a magnetic disturbance. It can also be affected by accessories such as antennas and roof racks that are mounted by magnets.

READ NEXT:

 Compass Calibration

If you see ‘‘- -’’ in the direction display when you turn the ignition switch to the ON (II) position, the compass is self-calibrating. The compass may need to be manually calibrate

 Compass Zone Selection

In most areas, there is a variation between magnetic north and true north. Zone selection is required so the compass can compensate for this variation. To check and select the zone, do this:

 Security System

If equipped The security system helps to protect your vehicle and valuables from theft. The horn sounds and a combination of headlights, parking lights, side marker lights and taillights flash

SEE MORE:

 ATF Replacement

NOTE: Keep all foreign particles out of the transmission. 1. Park the vehicle on the level ground. 2. Warm up the engine to normal operating temperature (the radiator fan comes on), and turn the engine off. 3. Remove the drain plug (A), and drain the automatic transmission fluid (ATF). NOTE: If

 DTC P0010: VTC Oil Control Solenoid Valve Malfunction

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the ignition switch ON (II). 2. Clear the DTC with the HDS. 3. Start the engine. Hold the engine speed at 3,000 rpm without load (in Park or neutral) until

© 2016-2025 Copyright www.hcrv.net