Honda CR-V: DTC Troubleshooting
READ NEXT:
DTC P0010: VTC Oil Control Solenoid Valve
Malfunction
NOTE: Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
1. Turn the ignition switch ON (II).
2. Clear the DTC with the H
DTC P1009: VTC Advance Malfunction
NOTE:
Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
If DTC P0341 is stored at the same time as DTC P1009,
trouble
VTC Oil Control Solenoid Valve Removal/Test/Installation
1. Disconnect the VTC oil control solenoid valve 2P
connector (A).
2. Remove the bolt (B) and the VTC oil control
solenoid valve (C).
3. Check the VTC oil control solenoid valve strainer
for cloggin
SEE MORE:
HVAC (Heating, Ventilation, and Air Conditioning)
Special Tools
Backprobe set
Component Location Index
SERVICE VALVE (HIGH-PRESSURE SIDE)
SERVICE VALVE (LOW-PRESSURE SIDE)
EVAPORATOR CORE (Located-in the heater unit)
RECEIVER/DRYER DESICCANT
Replacement
A/C CONDENSER
Replacement
Clutch Check
Clutch Overhaul
Thermal Prote
DTC 82-14: No Signal From the Front
Passenger's Weight Sensor (front inner side)
NOTE: Before doing this troubleshooting procedure,
review SRS Precautions and Procedures.
1. Erase the DTC memory.
2. Read the DTC.
Is DTC 82-14 indicated?
YES-Go to step 3.
NO-Intermittent failure, the system is OK at this
time. Go to Troubleshooting Intermittent Failures.
3. From the SRS INSPE
© 2016-2025 Copyright www.hcrv.net
