Honda CR-V: DTC Troubleshooting

READ NEXT:

 DTC P0010: VTC Oil Control Solenoid Valve Malfunction

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the ignition switch ON (II). 2. Clear the DTC with the H

 DTC P1009: VTC Advance Malfunction

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. If DTC P0341 is stored at the same time as DTC P1009, trouble

 VTC Oil Control Solenoid Valve Removal/Test/Installation

1. Disconnect the VTC oil control solenoid valve 2P connector (A). 2. Remove the bolt (B) and the VTC oil control solenoid valve (C). 3. Check the VTC oil control solenoid valve strainer for cloggin

SEE MORE:

 F-CAN Circuit Troubleshooting

NOTE: Information marked with an asterisk (*) applies to the CANL line. 1. Turn the ignition switch OFF. 2. Jump the SCS line with the HDS. 3. Disconnect PCM connector A (44P), then disconnect the HDS. 4. Measure resistance between PCM connector terminals A36 and A37. Is there about 95- 116 Ω

 VTC Actuator, Exhaust Camshaft Sprocket Replacement

Removal 1. Remove the cam chain. 2. Hold the camshaft with an open-end wrench, then loosen the variable valve timing control (VTC) actuator mounting bolt and exhaust camshaft sprocket mounting bolt. 3. If the VTC actuator will be reused, do these steps. Remove the intake camshaft, and seal the

© 2016-2025 Copyright www.hcrv.net