Honda CR-V: DTC Troubleshooting

READ NEXT:

 DTC P0010: VTC Oil Control Solenoid Valve Malfunction

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the ignition switch ON (II). 2. Clear the DTC with the H

 DTC P1009: VTC Advance Malfunction

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. If DTC P0341 is stored at the same time as DTC P1009, trouble

 VTC Oil Control Solenoid Valve Removal/Test/Installation

1. Disconnect the VTC oil control solenoid valve 2P connector (A). 2. Remove the bolt (B) and the VTC oil control solenoid valve (C). 3. Check the VTC oil control solenoid valve strainer for cloggin

SEE MORE:

 To Select a File from Folder and File Lists

You can also select a folder or file by using the VOL/SELECT knob. Push the VOL/SELECT knob to switch the display to the folder or file list, then turn the VOL/SELECT knob to select a folder or file. Press the VOL/SELECT knob to set your selection. Pressing the button goes back to

 The Starter Operates Normally

In this case, the starter motor’s speed sounds normal, or even faster than normal, when you turn the ignition switch to the START (III) position, but the engine does not run. Are you using a properly coded key? An improperly coded key will cause the immobilizer system indicator in t

© 2016-2025 Copyright www.hcrv.net