Honda CR-V: VTEC/VTC
Honda CR-V (2006–2011) Service Manual / Fuel and Emissions / VTEC/VTC
Component Location Index
-
ROCKER ARM OIL CONTROL VALVE
-
Removal/Installation
-
-
ROCKER ARM OIL PRESSURE SWITCH
-
Removal/Installation
-
-
CAMSHAFT POSITION (CMP) SENSOR A (INTAKE)
-
Replacement
-
-
POWERTRAIN CONTROL MODULE (PCM)
-
General Troubleshooting Information,
Replacement
-
-
VTC STRAINER
-
VTC OIL CONTROL SOLENOID VALVE
-
Removal/Installation
-
READ NEXT:
DTC P0010: VTC Oil Control Solenoid Valve
Malfunction
NOTE: Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
1. Turn the ignition switch ON (II).
2. Clear the DTC with the H
DTC P1009: VTC Advance Malfunction
NOTE:
Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
If DTC P0341 is stored at the same time as DTC P1009,
trouble
SEE MORE:
Cylinder Head Removal
NOTE:
Use fender covers to avoid damaging painted
surfaces.
To avoid damage, unplug the wiring connectors
carefully while holding the connector portion.
To avoid damaging the cylinder head, wait until the
engine coolant temperature drops below 100 ºF
(38 ºC) before loosening the cylinder h
Transmission End Cover
End Cover Removal
Special Tools Required
Mainshaft holder 07GAB-PF50101 or 07GAB-PF50100
NOTE: The illustration shows the 4WD transmission; the 2WD is similar.
1. Remove the cooler inlet line bolt (D), sealing washers, and line bracket
bolts (E), and remove the ATF cooler inlet
line (F).
2. Remove
© 2016-2026 Copyright www.hcrv.net
