Honda CR-V: VTEC/VTC
Honda CR-V (2006–2011) Service Manual / Fuel and Emissions / VTEC/VTC
Component Location Index
-
ROCKER ARM OIL CONTROL VALVE
-
Removal/Installation
-
-
ROCKER ARM OIL PRESSURE SWITCH
-
Removal/Installation
-
-
CAMSHAFT POSITION (CMP) SENSOR A (INTAKE)
-
Replacement
-
-
POWERTRAIN CONTROL MODULE (PCM)
-
General Troubleshooting Information,
Replacement
-
-
VTC STRAINER
-
VTC OIL CONTROL SOLENOID VALVE
-
Removal/Installation
-
READ NEXT:
DTC P0010: VTC Oil Control Solenoid Valve
Malfunction
NOTE: Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
1. Turn the ignition switch ON (II).
2. Clear the DTC with the H
DTC P1009: VTC Advance Malfunction
NOTE:
Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
If DTC P0341 is stored at the same time as DTC P1009,
trouble
SEE MORE:
Recirculation Control Motor
Circuit Troubleshooting
1. Check the No. 36 (10 A) fuse in the under-dash fuse/
relay box.
Is the fuse OK?
YES-Go to step 2.
NO-Replace the fuse, and recheck. If the fuse blows again, check for a short in
the No. 36 (10 A) fuse circuit.
2. Disconnect the recirculation control motor 7P
connector.
3. Turn the ignition s
Changing a Tire with TPMS
If you have a flat tire, the low tire
pressure indicator will come on.
Replace the flat tire with the
compact spare tire.
Each wheel (except the compact
spare tire wheel) is equippedwith a
tire pressure sensor. You must use
TPMS specific wheels. It is
recommended that you always have
© 2016-2025 Copyright www.hcrv.net
