Honda CR-V: Replacing a High-mount Brake Light Bulb

1. Open the tailgate.
Unlatch the top of the cover by
pulling back on it with your hands.

2. Place a cloth on the side edge of
the cover to prevent scratches.
Remove the cover by carefully
prying on the edge with a small
flat-tip screwdriver and pulling the
cover off.
3. Remove the socket from the light
assembly by turning it one-quarter
turn counterclockwise.

4. Pull the bulb straight out of its
socket. Push the new bulb straight
into the socket until it bottoms.
5. Press the brake pedal to make
sure the new bulb is working.
6. Put the socket back into the light
assembly, and turn it clockwise to
lock it in place.
7. Put the cover back on the light
assembly. Push it in until it locks
in place.
READ NEXT:
Dirt build-up in the loops of the seat
belt anchors can cause the belts to
retract slowly. Wipe the insides of
the loops with a clean cloth
dampened in mild soap and warm
water or isopropy
The floor mats that came with your
vehicle hook over the floor mat
anchors. This keeps the floor mats
from sliding forward, possibly
interfering with the pedals, or
backwards, making the f
Your vehicle is equipped with an
antenna at the rear of the roof . Bef ore
using a ‘‘drive-through’’ car wash,
remove the antenna by unscrewing it by
hand. This prevents the antenna
SEE MORE:
Removal
1. Drain the engine coolant.
2. Remove the air cleaner housing.
3. Remove the harness holder (A) from the bracket,
then remove the harness holder bracket (B).
4. Remove the upper radiator hose (A), heater hose
(B), and water bypass hose (C).
5. Remove the air cleaner housing brackets.
6
NOTE:
The MICU turns on the headlights (high beams) in a dim mode for the
daytime running lights under the following
conditions:
The ignition switch is ON (II)
The headlight switch is OFF
The parking brake is released (parking brake switch OFF)
If the vehicle is equipped with an opti
© 2016-2025 Copyright www.hcrv.net
