Honda CR-V: MICU Input Test

NOTE:

1. Before testing, troubleshoot the B-CAN System Diagnosis Test Mode A.

2. Check the No. 12 (10 A), No. 13 (10 A), No. 15 (7.5 A), No. 16 (10 A), No. 17 (10 A), No. 18 (20 A), No. 19 (15 A), No. 21 (30 A), and No. 37 (7.5 A) fuses in the under-dash fuse/relay box. If any fuse is blown, replace it and go to step 3.

3. Disconnect the under-dash fuse/relay box connectors E, F, G, M, S, and T.

NOTE: All connector views are wire side of female terminals.

Honda CR-V. Exterior Lights

Honda CR-V. Exterior Lights

4. Inspect the connector and socket terminals to be sure they are all making good contact.

5. With the connectors still disconnected, make these input tests at the appropriate connector.

Honda CR-V. Exterior Lights

6. Reconnect the connectors, and do these input tests at the connectors.

Honda CR-V. Exterior Lights

Honda CR-V. Exterior Lights

Combination Light Switch Test/Replacement

1. Remove the dashboard lower cover.

2. Remove the steering column covers.

3. Disconnect the 12P connector (A) from the combination light switch (B).

Honda CR-V. Exterior Lights

4. Remove the two screws, then slide out the combination light switch.

5. Inspect the connector terminals to be sure they are all making good contact.

Light switch

Honda CR-V. Exterior Lights

Turn signal switch

Honda CR-V. Exterior Lights

6. If the continuity is not as specified, replace the switch.

READ NEXT:

 Headlight Adjustment

CAUTION Headlights become very hot during use; do not touch them or any attaching hardware immediately after they have been turned off. Before adjusting the headlights: Park the vehicle on a level s

 Turn Signal/Hazard Flasher

Component Location Index TURN SIGNAL SWITCH (Built into the combination light switch) TURN SIGNAL INDICATORS HAZARD WARNING SWITCH MICU (Built into the under-dash fuse/relay box) Circuit Diagr

 Interior Lights

Component Location Index With moon roof INDIVIDUAL MAP LIGHTS INTERIOR LIGHT SWITCH (Built into the moonroof switch) AMBIENT LIGHT (Built into the moonroof switch) CEILING LIGHT CARGO AREA LI

SEE MORE:

 Conventional Brake Components

Special Tools Brake Caliper Piston  Compresor Component Location Index BRAKE SYSTEM INDICATOR Circuit Diagram Parking Brake Switch Test Brake Fluid Level Switch Test BRAKE HOSE and LINE Inspection Brake Hose Replacement PARKING DRUM BRAKE Inspection Shoe Replace

 Replacing Rear Bulbs

1. Open the tailgate. Place a cloth on the edge of the cover to prevent scratches. Remove the covers by carefully prying on the edge with a small flat-tip screwdriver. 2. Use a Phillips-head screwdriver to remove the taillight assembly mounting screw under each cover. 3. Pull the t

© 2016-2025 Copyright www.hcrv.net