Honda CR-V: Changing the Set Speed

You can increase the set cruising speed in any of these ways:

Press and hold the RES/ACCEL button. When you reach the desired cruising speed, release the button.

To increase the speed in very small amounts, tap the RES/ ACCEL button. Each time you do this, your vehicle will speed up about 1 mph (1.6 km/h).

Push on the accelerator pedal.

Accelerate to the desired cruising speed, then press the SET/ DECEL button.

You can decrease the set cruising speed in any of these ways:

NOTE: If you need to decrease your speed quickly, use the brakes as you normally would.

To slow down in very small amounts, tap the SET/DECEL button. Each time you do this, your vehicle will slow down about 1 mph (1.6 km/h).

Press and hold the SET/DECEL button. Release the button when you reach the desired speed.

Tap the brake pedal lightly with your foot. The CRUISE CONTROL indicator on the instrument panel goes out. When the vehicle slows to the desired speed, press the SET/DECEL button.

Even with the cruise control turned on, you can still use the accelerator pedal to speed up for passing. After completing the pass, take your foot off the accelerator pedal. The vehicle will return to the set cruising speed.

Resting your foot on the brake pedal causes cruise control to cancel.

READ NEXT:

 Canceling Cruise Control

You can cancel cruise control in any of these ways: Tap the brake pedal. Push the CANCEL button on the steering wheel. Push the CRUISE button on the steering wheel.

 Resuming the Set Speed

When you push the CANCEL button, or tap the brake pedal, the system remembers the previously set speed. To return to that speed, accelerate to above 25 mph (40 km/h), and then press and relea

 Bluetooth HandsFreeLink

On models with navigation system Bluetooth HandsFreeLink (HFL) allows you to place and receive phone calls using voice commands, without handling your cell phone. To use HFL, you need a Bluet

SEE MORE:

 DTC P16CO: PCM A/T Control System Incomplete Update

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review General Troubleshooting Information. This code is indicated when PCM updating is incomplete. 1. Update the A/T software in the PCM. 2. Check whether the DTC P16CO is indicated in the DTCs/Freeze Data

 Passenger's Tray Removal/Installation

Special Tools Required KTC trim tool set SOJATP2014 * * Available through the American Honda Tool and Equipment Program; call 888-424-6857 SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service. NOTE: Use the a

© 2016-2025 Copyright www.hcrv.net