Honda CR-V: VTEC/VTC
Honda CR-V (2006–2011) Service Manual / Fuel and Emissions / VTEC/VTC
Component Location Index
-
ROCKER ARM OIL CONTROL VALVE
-
Removal/Installation
-
-
ROCKER ARM OIL PRESSURE SWITCH
-
Removal/Installation
-
-
CAMSHAFT POSITION (CMP) SENSOR A (INTAKE)
-
Replacement
-
-
POWERTRAIN CONTROL MODULE (PCM)
-
General Troubleshooting Information,
Replacement
-
-
VTC STRAINER
-
VTC OIL CONTROL SOLENOID VALVE
-
Removal/Installation
-
READ NEXT:
DTC P0010: VTC Oil Control Solenoid Valve
Malfunction
NOTE: Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
1. Turn the ignition switch ON (II).
2. Clear the DTC with the H
DTC P1009: VTC Advance Malfunction
NOTE:
Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
If DTC P0341 is stored at the same time as DTC P1009,
trouble
SEE MORE:
Important Maintenance Precautions
If you have the required service
done but do not reset the display, or
reset the display without doing the
service, the system will not show the
correct maintenance intervals. This
can lead to seriousmechanical
problems because you will no longer
have an accurate record of when
maint
Front Seat
Front Seat Active Head Restraint Inspection
NOTE: If the vehicle has been in a collision, always
inspect the active head restraints, even if they appear
reusable, by doing the following procedure.
Resetting Head Restraint Position
1. Push the head restraint (A) forward fully from the
locked position
© 2016-2026 Copyright www.hcrv.net
