Honda CR-V: Replacing a Parking Light/Front Side Marker Light Bulb

Honda CR-V (2006–2011) Owner's Manual / Maintenance / Lights / Replacing a Parking Light/Front Side Marker Light Bulb

1. Open the hood.

1. Open the hood.

To change the parking light/front side marker on the driver’s side, remove the fuse box fromits stay by pulling out.

2. Remove the socket from the

2. Remove the socket from the headlight assembly by turning it one-quarter turn counterclockwise.

3. Pull the bulb straight out of its socket. Push the new bulb straight into the socket until it bottoms.

4. Insert the socket back into the headlight assembly. Turn it clockwise to lock it in place.

5. Turn on the lights to make sure the new bulb is working.

6. (Driver’s side)
Reinstall the fuse box in place securely.

READ NEXT:

 Replacing Rear Bulbs

1. Open the tailgate. Place a cloth on the edge of the cover to prevent scratches. Remove the covers by carefully prying on the edge with a small flat-tip screwdriver. 2. Use a Phillips-h

 Replacing a High-mount Brake Light Bulb

1. Open the tailgate. Unlatch the top of the cover by pulling back on it with your hands. 2. Place a cloth on the side edge of the cover to prevent scratches. Remove the cover by carefully

 Cleaning the Seat Belts

Dirt build-up in the loops of the seat belt anchors can cause the belts to retract slowly. Wipe the insides of the loops with a clean cloth dampened in mild soap and warm water or isopropy

SEE MORE:

 To Remove Exterior Frost or Ice Fromthe Windows

1. Select . The system automatically switches to fresh air mode and turns on the A/C. The A/C indicator does not come on if it was off to start with. 2. Select . 3. Set the fan and temperature controls to maximum level. To clear the windows faster, you can close the dashboard corner

 DTC P0712: Short in ATF Temperature Sensor Circuit

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review General Troubleshooting Information. This code is caused by an electrical circuit problem and cannot be caused by a mechanical problem in the transmission. 1. Check the ATF temperature sensor voltage

© 2016-2025 Copyright www.hcrv.net